CCNA v2.0, section 4.0, lab 2, in slides: find the replies lost at the ISP in Packet Tracer, then set up PAT on R1 for the HQ LAN and read the ports while two PCs browse, map WEB1 to a public address for a laptop on the internet, give the branch a pool first one to one and then with overload, set up PAT on the backup router and fail over to it, read the statistics and the debug; then break NAT in five ways and find each fault.
The slides
The lab is twenty-two slides in seven parts, after an introduction, one step each.
- Introduction: what the lab does, and what it needs.
- 1. The replies with no way back: the starting network checked, the ISP's routes back to the company removed, and a ping from PC1 whose replies stop at the ISP.
- 2. PAT for HQ: access list 1, the inside and outside interfaces, PAT on G0/2, and the ports of two browsers.
- 3. Static NAT for WEB1: RA on the internet, the ISP's route to the pool, and WEB1 mapped to
203.0.113.17. - 4. A pool for the branch: access list 2 and the pool
BRANCH, one address per host, then with overload. - 5. NAT on the backup edge: PAT on R2, and R1's uplink shut so that R2 takes over.
- 6. Watching NAT work:
show ip nat statistics, debug ip nat, and saving. - 7. Breaking NAT: an inside interface marked outside, an ACL with the wrong subnet, a one-address pool without overload, a static mapping the ISP does not route, and R2 without its outside interface.
The files
- The network it starts from:
lab4-1.pkt, built in
the previous lab; the settings it assumes (addressing, OSPF, the default routes, HSRP, and the ISP's routes back from
Lab 3.2) are in START.txt. - The configurations it builds: each device's configuration, as plain text, in the
ccna repository.
- What it saves:
lab4-2.pkt, the start of the next lab. - The lesson:
NAT and PAT.