CCNA v2.0, section 4.0, lesson 2, in slides: private addresses and the replies lost without NAT, inside local, inside global, outside local and outside global drawn on a packet before and after the router, static NAT for a server, dynamic NAT with a pool and an exhausted pool, PAT and its table connection by connection, PAT on the interface or on a pool, inside and outside interfaces, the ACL and the NAT commands, the order of operations, show ip nat translations and statistics, debug ip nat, clearing translations, and NAT on IOS XE.
The slides
The lesson is twenty-two slides in seven sections, after an introduction. R1, the edge router of the company network, translates throughout.
- Introduction: the company network, and the lesson's seven sections.
- 1. Private addresses and NAT: the RFC 1918 ranges, a ping whose replies are lost at the ISP, and NAT as the answer.
- 2. The four addresses: inside local, inside global, outside local and outside global, on a packet leaving the inside and on its reply.
- 3. Static NAT: WEB1 reachable from the internet at one fixed address, and its configuration.
- 4. Dynamic NAT with a pool: hosts taking addresses from a pool, and the pool running out.
- 5. PAT: NAT overload: one address shared by port, the NAT table connection by connection, and PAT on the interface or on a pool.
- 6. Configuring and verifying NAT: inside and outside interfaces, the ACL and the NAT commands, the order of operations,
show ip nat translations and statistics, debug ip nat, clearing translations, and IOS XE. - 7. The kinds compared, and the lab: static NAT, dynamic NAT and PAT side by side, and the network Lab 4.2 builds.
The buttons on the left and right edges move between slides. So do the arrow keys and a swipe.
The lab
Sources