CCNA v2.0, section 3.0, lab 3, in slides: remove the static routes between three routers in Packet Tracer and run OSPFv2 in their place, with loopback router IDs, point-to-point links, R1 as the DR of the HQ LAN, a passive LAN, the default route and the reference bandwidth; add OSPFv3 for IPv6; then break OSPF in six ways and find each fault with the show commands.
The slides
The lab is twenty-two slides in four parts, after an introduction, one step each.
- Introduction: what the lab does, and what it needs.
- 1. Forming the neighbors: the static routes removed, a loopback per router, OSPF enabled with network statements on R1 and on the interfaces of R2 and R3, point-to-point links, and R1 made the DR.
- 2. Shaping the routes: a passive LAN and the default route, the reference bandwidth, each router's neighbors, and R3's routes tested from PC3.
- 3. Adding OSPFv3: OSPFv3 on the three routers, its neighbors and routes, and saving.
- 4. Breaking OSPF: a hello interval, an area, a duplicate router ID, a passive link, a network type and a priority of 0, each found with the show commands, and the six compared.
The files
- The network it starts from:
lab3-2.pkt, built in
lab 3.2. It saves lab3-3.pkt. - The configurations it builds: each router's configuration, as plain text, in the
ccna repository.
- The lesson:
Single-Area OSPF.