CCNA v2.0, section 2.0, lab 1, in slides: build one 2960 switch with two PCs, a printer and an IP phone with a PC behind it in Packet Tracer; create three VLANs, put each port in its VLAN with a voice VLAN for the phone, and watch a ping and an ARP request stop at the VLAN's edge; then break the VLANs in three ways and find each fault.
The slides
The lab is eighteen slides in three parts, after an introduction, one step each, with the steps to follow beside the network, a terminal or a table.
- Introduction: what the lab does, and what it needs.
- 1. Building the switch and its hosts: the devices and cables, the phone's power, the hosts' addresses, the switch's name, and a ping to every host.
- 2. Putting the hosts in VLANs: three VLANs, the access ports and the voice VLAN,
show vlan brief and show interfaces switchport, the ping again, PC1's ARP request in simulation mode, PC2's own subnet, and saving. - 3. Breaking the VLANs: a port in the wrong VLAN, a deleted VLAN, and a host port turned into a trunk.
The files