CCNA v2.0, section 1.0, lab 5, in slides: split a /48 into /64 networks, derive an EUI-64 address by hand and check it against the router, add IPv6 to Lab 3's network in Packet Tracer with static addresses, EUI-64, a unique local prefix and SLAAC on the PCs, name the type of every address, and test end to end; then break the IPv6 addressing in four ways and find each fault.
The slides
The lab is twenty slides in three parts, after an introduction, one step each.
- Introduction: what the lab does, and what it needs.
- 1. Planning the addresses: the /48 split into /64 networks, the address plan, and R2's EUI-64 address derived by hand.
- 2. Adding IPv6: R1, R2 (EUI-64) and R3 (the unique local prefix), the ISP and the two servers, the ready-made routes, SLAAC on the PCs, each address named by its type, pings end to end, and R1's neighbor table.
- 3. Breaking the network: IPv6 routing removed from R1, a /127 on R2's G0/1, R3's prefix mistyped, and R1's G0/0 left with a link-local address alone, compared in one table.
The buttons on the left and right edges move between slides. So do the arrow keys and a swipe.
The files
- The network it starts from:
lab3.pkt, built in
Lab 3. - The configurations it adds: each router's IPv6 lines, the routes included, and the hosts' settings, as plain text, in the
ccna repository.
- The network it builds:
lab5.pkt; the fault round starts from it. - The lesson:
IPv6 Addressing.