CCNA v2.0, section 1.0, lesson 3, in slides: binary and the mask, prefix lengths, network and broadcast addresses and the host range, the block size, subnetting and VLSM on one /24 cut largest first, the RFC 1918 private ranges and why a private address needs NAT, the four host parameters, how a host decides between its own subnet and its gateway, connected routes, addressing IOS interfaces, ipconfig, ip addr and ifconfig, ping and traceroute, and five addressing faults.
The slides
The lesson is twenty-three slides in six sections, after an introduction. The network is a company with three sites and one internet provider, addressed from 10.10.0.0/24.
- Introduction: the network and its five subnets.
- 1. Prerequisite: binary and the mask: place values and conversion, the mask and the AND that gives the network address, and the prefix length beside the mask's nine octet values.
- 2. Network, broadcast and host addresses: the three special parts of a subnet for /24, /26 and /30, and the block size that finds them without binary.
- 3. Subnetting and VLSM: borrowed host bits, sizing a subnet for its hosts, the /24 cut largest first, and the rule that a block starts at a multiple of its size.
- 4. Public and private addresses: the RFC 1918 ranges and the other reserved ones, and NAT as the reason a private address can reach the internet.
- 5. Hosts, routers and their commands: the four host parameters, the host's decision between its subnet and its gateway, connected and local routes, addressing an IOS interface, the client commands on Windows, Linux and macOS, and ping and traceroute.
- 6. Addressing faults: a wrong mask, a wrong gateway, overlapping subnets, a host on the network or broadcast address, and a duplicate address.
The buttons on the left and right edges move between slides. So do the arrow keys and a swipe.
The lab
Sources